I flushed my transmission at 113,000 didn't look like it had been done before. The fluid looked pretty clean and there was no debris in the bottom of the pan so I was feeling pretty happy. Well after that i noticed a small drip developing on my garage floor. At first I though that my pan was leaking where the gasket didn't seal up right. Upon closer inspection I realised that it is coming from a "breather?" hole between the trans and the transfer case. I figured it was a seal between the two that had started leaking.
This is what has me nervous. The guy I was talking to said that it is a bushing that is in there and what happens is there is a feed and return to the bushing and more than likely the return is plugged and so it is pressurizing and oil is leaking out. Also said this means ripping into the trans to fix it.
Please does anyone have experience with something like this? Any help or suggestions are more then welcome. I am freaking out right now. I will try to post a picture here so you can see what hole I am talking about.
and
