Does anyone know the max end play of the driveshafts?
Measured here
?
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| C clip question http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=56744 |
Page 1 of 1 |
| Author: | tonycrd [ Sun Nov 07, 2010 1:49 pm ] |
| Post subject: | C clip question |
Does anyone know the max end play of the driveshafts? Measured here ? |
|
| Author: | tjkj2002 [ Sun Nov 07, 2010 8:32 pm ] |
| Post subject: | Re: C clip question |
From the FSM it should be no more then 0.005",if more you need to add a thicker shim behind the side gears which you can not do in a ARB that you are getting.Could have worn side gears that need to be replaced as pairs and everything measured to get the correct shims and end play. |
|
| Author: | XJMA [ Mon Nov 08, 2010 2:23 pm ] |
| Post subject: | Re: C clip question |
There is usually between 1/8 and 1/4" play on the axle shaft with a C-clip axle. Once you start driving it, it will go away and you won't notice it. A little axial play is normal for the C-clip axles. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|