More than likely front driveshaft
Get a front replacement shaft
don't cut and slice
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| rumbling vibration http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=57065 |
Page 1 of 1 |
| Author: | Strikeagle [ Tue Nov 23, 2010 3:27 am ] |
| Post subject: | rumbling vibration |
getting rumbling vibration from under drivers side when driving loudest at 65 and mostly goes away when put into 4 hi part time. sounds like coming from the transfer case. anyone have that problem at some point? |
|
| Author: | DirtyKK [ Tue Nov 30, 2010 6:23 am ] |
| Post subject: | Re: rumbling vibration |
Check your u joints on the rear driveshaft. Also check for play in the front driveshaft, its cv is notorious for going out. |
|
| Author: | Lima.Charlie [ Tue Nov 30, 2010 8:33 am ] |
| Post subject: | Re: rumbling vibration |
If it is your FDS, take it to a driveline shop and have them cut the companion joint off and put a U-joint on. I know 3 people that have done it including myself. |
|
| Author: | tommudd [ Tue Nov 30, 2010 1:47 pm ] |
| Post subject: | Re: rumbling vibration |
More than likely front driveshaft Get a front replacement shaft don't cut and slice
|
|
| Author: | Lima.Charlie [ Tue Nov 30, 2010 5:44 pm ] |
| Post subject: | Re: rumbling vibration |
I cgot my cut and sliced almost 6 months ago with not one single issue. No vibration. No nothing. I would recommend it, some obviously won't. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|