Daystar 1.5 inch spacer kit

i want to make sure this will make my liberty level anyones will help thanks
http://www.amazon.com/gp/product/B001GH ... ss_product

_________________
2004 jeep liberty 3.7l
general grabber at2
K&n cold air intake
dynomax cat back exhaust
front tow hooks
hitch with D ring shackle
LED interior
Pioneer speaker upgrade
some skids
alpine head unit

save yourself some money and hassle with the install of that and PM Boiler to order a 3/8" strut shim.

i don't mind ill be doing the work myself i have my own shop just want to be sure it will be level

_________________
2004 jeep liberty 3.7l
general grabber at2
K&n cold air intake
dynomax cat back exhaust
front tow hooks
hitch with D ring shackle
LED interior
Pioneer speaker upgrade
some skids
alpine head unit

daystar spacer kit is crap....get the shims...it WILL be Level...promise

_________________
2002 KJ Limited 3.7, 5.25" lift via coilovers, custom HD rear springs, 32.2" tires on moabs (soon 33s) 4.56/JBA diff, OX lockers front/rear, NP241OR, Parker Fab front/rear bumpers, rock rails and roof rack, Viair OBA.

2006 KJ sport 3.7, 4" Ironman lift, 32" tires, Parker Fab front/rear bumpers and rock rails.

So you would need 4 shims each side to equal 1.5 lift of the Daystar? What is the cost of 8 shims? Is it ok to put that many on there?

_________________
2003 Jeep Liberty Limited
Goodyear Duratracs 245/75/16
Crager Soft 8's 16x7
OME/Bilstein

No just one pair of strut shims is needed to be level. If you put that daystar spacer in the front it would set higher in the front then the rear.

If you install this in the front, you will also need to install a couple rear spring isolator pads in the rear to make it level. These install IN the front spring booty'y. You will effectively being adding a 1.5" lift to the front and nothing in the rear.



NO! You can only install 1 set of these shims. These shims go on top of the spring pack between the spring and the body. There is only enough threads on the top of the spring pack to add one set ( 1 on each side ) or you won't have any threads going through to put the nuts on top.

Icecold: if you are only looking to remove the slight front rake that the stock libby has, 1 set of shims should make you level.

_________________
02 Red KJ Sport,33s,custom fenders,custom roof rack,custom 5" susp, cradle drop,V8 swap
[url=http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=68&t=64049]04 KJ, 4" Fox coilovers, Bilstein, 33's, RL front bumper
'05 WK Limited, Hers

And if boiler's shim still doesn't bring you level ( mucho sagged front springs) you can add couple conduit nuts under the front clevis to bring up slightly also.

_________________
'99 Tahoe, 3" BL, 285/75/16's , MT II's.
'05 Liberty Sport, -wifey's
'98 Poncho Fireturd, 3.8L, .....the purple pig!