LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Oil Light Has Started Coming on
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=57661
Page 1 of 1

Author:  scull20 [ Mon Dec 20, 2010 10:49 am ]
Post subject:  Oil Light Has Started Coming on

Greetings,

I was curious if any of you fine folks would be able to provide some insight with an issue that I've been having lately.

First off, while I'm at school I park in the very bottom level of an underground parking garage. It usually stays between 40-50 degrees F down there in the winter. On Friday, I came home for Christmas break and have been parking outside since. On Saturday morning I started my Liberty up after it sat overnight in the cold and was greeted with the red oil light in the center of the dash. I let it warm up, turned it off and turned it back on and the light was gone. Last evening, same thing...turned it off, turned it back on and the light was off. I drove to my destination...about 6 miles away, let it sit (on level ground) for about 10 minutes...pulled the dip stick and checked the level twice, everything was fine. On my way to work this morning, same thing happened...though this time I turned it off immediately, then turned started it again and the light was off.

Anyone have any ideas as to why the light is coming on?

Thanks for any help!

-Ryan


EDIT: The only thing I can think of is the oil being thicker because of the weather.

Author:  Neal [ Mon Dec 20, 2010 12:39 pm ]
Post subject:  Re: Oil Light Has Started Coming on

Change out the oil pressure sender, near the filter.

Author:  JeepinJarhead03 [ Mon Dec 20, 2010 6:06 pm ]
Post subject:  Re: Oil Light Has Started Coming on

x3

pretty sure it's PN# 2242 oil pressure sensor 100PSI for NO Gauge advance/autozone/etc

bout 35 bucks

Author:  scull20 [ Tue Dec 21, 2010 8:34 pm ]
Post subject:  Re: Oil Light Has Started Coming on

Excellent, thanks for the help guys...I'm assuming its fairly self explanatory to put take the old one out and throw the new one in?

Author:  JeepinJarhead03 [ Tue Dec 21, 2010 9:04 pm ]
Post subject:  Re: Oil Light Has Started Coming on

yep, pretty self explanatory, just be careful of leaning too hard on lines and such, make sure to spin it backwards a few times until you feel it "click" into the threads to prevent it from cross threading, if it doesn't thread in smooth back it out and try again

just stuff like that, basically same care that's taken with most stuff, they aren't fragile, but they can be awkward!

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/