LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Front Carrier Bearing / Drive Shaft needs to be replaced???
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=57733		 Page 1 of 1
Author:  Greg Rose [ Thu Dec 23, 2010 5:14 pm ]
Post subject:  Front Carrier Bearing / Drive Shaft needs to be replaced???
Hello Everyone,

I recently took my '06 Liberty 4x4 (stock, 93k miles) in for a check up and was told that there is "play" in the front carrier bearing in the transfer case. At first the repair shop told me it was a basic repair where just the bearing could be swapped out but then said when they called Chrysler that the whole drive shaft needs to be replaced because the bearing is sealed inside.

Can anyone give me any intel on this? Is there a way to test whether this bearing needs to be replaced? And is it true that the whole drive shaft would need to be swapped out or is there a cheaper way to repair only the bearing?

Would really appreciate advice from anyone with knowledge on this.


Also want to wish everyone a Merry Christmas!


Warm regards,



Greg
Author:  Greg Rose [ Fri Dec 31, 2010 1:53 pm ]
Post subject:  Re: Front Carrier Bearing / Drive Shaft needs to be replaced
<BUMP>

Headed to the mechanic next week to check this out... would really appreciate any feedback or knowledge anyone has about this. Feel free to PM me or reply to this message.


Thanks!



Greg
Author:  tonycrd [ Fri Dec 31, 2010 2:02 pm ]
Post subject:  Re: Front Carrier Bearing / Drive Shaft needs to be replaced
Greg,

I think your mechanic ment that the rear CV on the propshaft to the front diff has play.

No bearings involved.

If you can confirm that, then we can help you.

You can get a repair kit for that shaft.

If it's not that, have him point out on this diagram which bearing Chrysler doesn't want to sell.

Image

Or was he talking about the front halve shafts? Or the intermediate shaft within the front diff?
Author:  Greg Rose [ Fri Dec 31, 2010 9:25 pm ]
Post subject:  Re: Front Carrier Bearing / Drive Shaft needs to be replaced
Tony,

Thanks so much for this info. I really appreciate it. Will speak to the mechanic next week and try to diagnose.


Best regards,



Greg
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/