| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| preparing for axle/intermediate replacement - questions? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=63885 |
Page 1 of 1 |
| Author: | jamangus [ Mon Nov 28, 2011 9:48 am ] |
| Post subject: | preparing for axle/intermediate replacement - questions? |
I have the reman NAPA half-shaft already. Where are you guys sourcing the intermediate shaft, seal and bearing? Also, are there any special tools required to pull/replace the recessed seal and bearing? Thanks. symptoms: Lots of up-down play on inboard side of axle; zero in-out play. On certain bumps, sounds like the whole front end will drop out.
|
|
| Author: | ramlebliberty [ Mon Nov 28, 2011 6:06 pm ] |
| Post subject: | Re: preparing for axle/intermediate replacement - questions? |
I'm gearing up for a whole front end replacement, I've seen interm. shafts around $130 on the web. I had horrible vibrations and thumping, then one day a loud popping like popcorn. Both CV's were toast and the clip inboard on the shaft popped off. Very interesting when I popped the dif. cover off. |
|
| Author: | jamangus [ Wed Nov 30, 2011 1:41 pm ] |
| Post subject: | Re: preparing for axle/intermediate replacement - questions? |
Any tips or tricks? I assume the intermediate shaft slides right out. Is there any retainer inside the diff? What about the seal and bearing? I don't see anyone changing them out. |
|
| Author: | jamangus [ Sun Dec 11, 2011 8:45 am ] |
| Post subject: | Re: preparing for axle/intermediate replacement - questions? |
found inner shaft/seal/bearing at rompalicious for decent price |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|