OK, Krazz1e and I are helping Gordo install his Rusty's spacer (OTT) lift, and we're having no luck getting the strut assembly reattached to the lower control arm. We've got the arm dropped as far as it can go, but the problem is that we can't seem to push the bottom of the strut assembly inward (toward the center of the vehicle) far enough to hit the perch.
Any ideas? We checked out the strut compressors at AutoZone, but neither of them looks like it can be used while the strut assembly is attached at the top.
The whole problem, as many of you already know, is that OTT lifts increase the overall length of the strut assembly, so it's almost impossible to reassemble without compressing it back to stock length.
So, any suggestions??? We're trying to get this done before dark!!!
TIA