Hi,

has anyone recently purchased one of these Front Mount Trailer Hitch for a 2003 Jeep Liberty?

http://www.etrailer.com/fmr-2003_Jeep_Liberty.htm

I have see some post where now a days they don't fit correctly, ie they are too low? is this correct? Would I need to curt it and re weld it? i don't want to buy something that I need to modify and so weaken it.

I am going to be using it with a Mountable winch.

Please advise.

Thank you

Fil.

_________________
CRD 2.5 2003

Snorkel
Curt Front Hitch+Warn M8000 & Cradel
Asfir Front, Gearbox,Transfer Skid + Mopar Tank Skid
BF Goodridge KM2 & General Grabbers AT 245/75R16
OME NS131&790 + NS132L&948, 3/8 Boiler Top Plate, JBA 4.5, 2 Top Rear Isolators

Anyone please?

Fil.

_________________
CRD 2.5 2003

Snorkel
Curt Front Hitch+Warn M8000 & Cradel
Asfir Front, Gearbox,Transfer Skid + Mopar Tank Skid
BF Goodridge KM2 & General Grabbers AT 245/75R16
OME NS131&790 + NS132L&948, 3/8 Boiler Top Plate, JBA 4.5, 2 Top Rear Isolators

Could be that nobody has one mounted on their Libby. It says that you have to remove some of the front bumper cover to mount it. You might ask them if they have a "mounted" picture to see how low it sits, or download the installation instructions. To me that would be the biggest issue, how much ground clearance would you sacrifice.

_________________
2004 KJ Limited
Eaton "e" locker front
Detroit Locker rear
Frankenlift II
245 75 16 Goodyear MTR's
Moabs
Al's UCA's
Boulderbars
Backbone with Warn XD9000i, Viking synthetic line
Rubicon Big Brother

viewtopic.php?f=5&t=63314&hilit=curt+front+hitch

There's one. jinstall did it and found it pretty frustrating.

_________________
2008 Jeep Liberty KK, SkySlider, Tow Package, OME/Bilstein Lift, Flowmaster Delta 50, Removed Resonator, DuraTracs, In-dash CB, PIAA 520 ATPs, Dual KJ Tow Hooks
http://www.cardomain.com/ride/3974106/2008-jeep-liberty
Lost Jeeps PNW/BC Members Map