| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Spacer kit http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=6587 |
Page 1 of 1 |
| Author: | BiB [ Sat Mar 11, 2006 11:13 am ] |
| Post subject: | Spacer kit |
The insructions for the spacer kit I have says to drop the lower control arm to install the spacer adove the strut. Will a strut compressor compress the strut the 3" in need ? or does the CA have to be droped for sure? If so are there any special instruction on droping it and reinstalling?Thanks in advance and many thanks for all the info I get from all of you.It helps alot Thanks again 
|
|
| Author: | Jeepjeepster [ Sat Mar 11, 2006 12:39 pm ] |
| Post subject: | |
You must drop the Lca then take the strut out to compress it. |
|
| Author: | Cards81fan [ Sat Mar 11, 2006 2:20 pm ] |
| Post subject: | |
Which kit? I did my Daystar and removed the struts by undoing the swaybar bolt, the upper ball joint, and removing the clevis. I never removed the LCAs. Of course, I DID get fancy with pry bar and spring compressors putting the longer strut back in the front. The trick is putting the lower clevis bolt back in. I used a spring compressor on the LCAs and clevis and tightened them to pull the eyelets into alignment, ran the bolt through, then tightened it all up. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|