What exactly is involved in getting the stock rear bumper assembly removed??

I'm looking into fabricating a steel bumper, and need to take a few measurements
for attachment points, etc.
I'm thinking it'll be easier to do with the bumper removed.

Any assistance will be helpful.

_________________
Brad
International Man of Mystery, Singer of Sentimental Ballads,
Soldier of Fortune, Guardian of the Holy Hand Grenade of Antioch,
Bass Player Extraordinaire, Keeper of the Eternal Flame
of the Immortals, Master Swordsman, The "5th" Beatle,
Expert Marksman, Stand-up Comedian, Martial Artist,
Jeep owner, and all around swell guy.

Fairly simple
You have fasteners along the top, open the tail gate you'll see them
also along the bottom
and you'll need to pull the bacj section of the flares and unbolt them
Fastener in behind the flares
Then you'll have the bracing in behind the cover

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited