LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Taller ride height after JBA's A-arm/ball joint swap
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=69745		 Page 1 of 1
Author:  2mopar_diesels [ Sat Jul 28, 2012 4:34 pm ]
Post subject:  Taller ride height after JBA's A-arm/ball joint swap
Anyone else experience a higher front end stance after installing new a-arms and ball joints? Front end is currently about an inch talker now than before I swapped out the worn OEM crap for JBA's units. Double and even triple checked everything to maker sure we did it right. Before you ask, yes...........we didn't tighten anything up until the full weight if the CRD was resting on the suspension and two of us (combined 400lb) on it hard to settle it.
Author:  tommudd [ Sun Jul 29, 2012 1:21 am ]
Post subject:  Re: Taller ride height after JBA's A-arm/ball joint swap
Has it been aligned yet if not
there ya go :wink:
Author:  2mopar_diesels [ Sun Jul 29, 2012 4:57 pm ]
Post subject:  Re: Taller ride height after JBA's A-arm/ball joint swap
Well, had the alignment done today.........and still no change!!! Not that I'm complaining, as it sits level now actually.
Author:  tommudd [ Sun Jul 29, 2012 5:36 pm ]
Post subject:  Re: Taller ride height after JBA's A-arm/ball joint swap
Control arms do not provide lift
Author:  2mopar_diesels [ Tue Jul 31, 2012 12:27 am ]
Post subject:  Re: Taller ride height after JBA's A-arm/ball joint swap
tommudd wrote:
Control arms do not provide lift


I know they don't, but the fact still remains..........the front end is sitting approx 1" taller now than before.
Author:  HoosierJeeper [ Tue Jul 31, 2012 6:41 pm ]
Post subject:  Re: Taller ride height after JBA's A-arm/ball joint swap
I thought the opposite happened. I just put in the Arms and added a slight clevis lift...not level though. (Didn't want it to be)
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/