| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Cylinder 3 and 6 misfire. Help! http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=75719 |
Page 1 of 1 |
| Author: | MtnRunner [ Mon Jun 24, 2013 5:35 pm ] |
| Post subject: | Cylinder 3 and 6 misfire. Help! |
Hey all, So I was driving down the road and my check engine light came on. I took it to NAPA and the guy told me the codes were cylinder 3 and 6 misfires. I went ahead and replaced all the coils and spark plugs. The problem did not resolve. In fact, it got worse a few days later. Here's where I am confused: When I start my liberty after it has been sitting for a long time, it shakes violently and my check engine light blinks (as in the cylinders are not firing the way they should be). When I turn my jeep off and immediately restart it, it runs fine and I can drive it. I'm thinking an ignition control unit is going out. Advice? Please and thank you. 2003 V6 |
|
| Author: | adamkrz [ Mon Jul 01, 2013 11:13 am ] |
| Post subject: | Re: Cylinder 3 and 6 misfire. Help! |
I Would do a compression test, I had new valves installed from the dealer when i had these codes. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|