LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Error codes on The KJ 2003 CRD
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=77826		 Page 1 of 1
Author:  goldy9091 [ Wed Dec 25, 2013 8:30 pm ]
Post subject:  Error codes on The KJ 2003 CRD
Hi Ladys and Gents

Just a question. I was driving on the M1 the other day and the ABS light and the Hand Brake light came on the dash, the speedo dropped to 0 kmh and the tacho was only sitting at 1500 - 2000rpm. I was doing 110kmh at the time, the trip meter wasnt rolling over either, i did about 40 km and it didnt change. The Cruise control doesnt work either now.

Just wondering if this is somthing serious i need to know about or if anyone has had this happen and should i have it looked at , it happened later in the day too but hasnt happened since, that was 3 days ago.

I have a 2003 KJ CRD Auto its up to 177,000km on the clock

Thanks in advance for any ideas you may have.

I have done the key on and off trick 4 times and 3 codes. P1610 , P0836 and P0340

I have seen the P0836 and P0340. P0836 said - transfer case position sensor and P0340 said camshaft position sensor circuit missing signal. I cant find what P1610 means.

Steve
Author:  ATXKJ [ Thu Dec 26, 2013 5:30 pm ]
Post subject:  Re: Error codes on The KJ 2003 CRD
No ideas - might post over in CRD...Love that torque - you'll get more diesel input

however 03 CRD was Oz and Europe - so you might have to explain what's different.

The speedo, cruise - makes me think that you lost a speed sensor - on 05's that's a wire on the rear differential

but that's pure guess.

(and Google did not find P1610 for a Jeep)
Author:  Glend [ Thu Dec 26, 2013 6:38 pm ]
Post subject:  Re: Error codes on The KJ 2003 CRD
I see this is also posted in the KJ section of Ausjeep so you will get more relevant input there, but off the top of my head I would agree its probably an ABS sensor or at least that's where I would start. Look at the rear axle you shoud see a single sensor that reads off the diff. It is posible you have a broken wire where it enters the diff - I have seen that before. I'd check that to start.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/