| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| looking for install instructions for a Rock lizard frnt bump http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=78762 |
Page 1 of 1 |
| Author: | Deussne [ Thu Apr 03, 2014 7:02 pm ] |
| Post subject: | looking for install instructions for a Rock lizard frnt bump |
Anyone got a copy of the installation instructions for the 02KJ Rock lizard front bumper? I bought a bumper from a guy, and unfortunatly it did not come with any instructions. I should be able to figure this out, however it would be a lot nicer to be able to read the original instructions. |
|
| Author: | tommudd [ Thu Apr 03, 2014 7:08 pm ] |
| Post subject: | Re: looking for install instructions for a Rock lizard frnt |
i have everything including pictures I took on my computer Problem is right now it is at the shop trying to get the demon virus out of it Should of been back yesterday but still waiting Hopefully tomorrow and I'll get it all together But its not hard at all to do Some little tricks though to get a nice clean tight fit |
|
| Author: | Deussne [ Thu Apr 03, 2014 7:54 pm ] |
| Post subject: | Re: looking for install instructions for a Rock lizard frnt |
That is what I am looking for. Tricks for a better install. Plus there are two brackets per side, I assume the angle bracket goes on the bottom, and the L shape bracket fits inside the rail? |
|
| Author: | Deussne [ Thu Apr 03, 2014 8:06 pm ] |
| Post subject: | Re: looking for install instructions for a Rock lizard frnt |
I cant wait to install this thing...  I am going to install a pre-runner guard on the top for some grille protection, also I got a CB antenna going on the driver front corner of that bumper. HF/UHF antenna on the roof. Not sure what winch yet. And the Jeep that it is all going to be installed on: 
|
|
| Author: | cj11 [ Fri Apr 04, 2014 6:24 am ] |
| Post subject: | Re: looking for install instructions for a Rock lizard frnt |
Hey pm me with your email I have the instructions. .. And yes the L pc goes in rail just need to remove a bit of metal from the hole in the rail and the angle goes on bottom and lines up with L... |
|
| Author: | cj11 [ Fri Apr 04, 2014 10:04 am ] |
| Post subject: | Re: looking for install instructions for a Rock lizard frnt |
  
|
|
| Author: | Deussne [ Sun Apr 06, 2014 4:31 pm ] |
| Post subject: | Re: looking for install instructions for a Rock lizard frnt |
For the turn signal harness what is the wire color combo? Where did you find which color goes with what? |
|
| Author: | tommudd [ Sun Apr 06, 2014 4:47 pm ] |
| Post subject: | Re: looking for install instructions for a Rock lizard frnt |
Sorry guys, my main computer with all of the photos/ writeup etc has been in the shop over 2 weeks now, using a little net book and can't access anything 
|
|
| Author: | Deussne [ Sun Apr 06, 2014 7:06 pm ] |
| Post subject: | Re: looking for install instructions for a Rock lizard frnt |
I got the bumper installed! I will post the pictures later. |
|
| Author: | Deussne [ Sun Apr 06, 2014 7:57 pm ] |
| Post subject: | Re: looking for install instructions for a Rock lizard frnt |
All done. Sorry for the crappy pictures. It was getting dark. I started at 9:00am and finished at 7:00pm.. Before:  After:   Sorry the KJ is a little dirty.. Plus looks like I will be needing some heavy duty springs. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|