hi guys - i went for a quick spin last night in the liberty 04 - its been stood for 6 weeks or so - i am putting it back on the road soon - i had a quick look underneath and noticed an oil leak on the back left hub inside - i am guessing that the problem is the oil seal - can you point me in the right direction as to how to do the job - drive shaft out etc ?
thanks in advance Dave P

_________________
Main car - jeep lberty 2004 2.8 crd- just fitted new front prop shaft ( transfer box end gone - splines included ) and new hub / bearing .
2nd car landrover defender 300 tdi - bit rough and ready
Home - Peak district UK

recently had this issue on a ford van. Seal was leaking due to the axle having a groove worn in it from a bad bearing. I would plan on replacing the axle...

_________________
2006 Liberty CRD 275K, JBA 2.5 with Fox Shocks, GDE Turbo Kit, GDE TCM Tune, Suncoast TC, OEM fuel filter housing converted to fit Caterpillar Fuel Filter 1R-0749, OEM themostat housing modified to accept Hemi 203 F thermostat.