| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Airflow Snorkel http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=81280 |
Page 1 of 1 |
| Author: | Balance156 [ Tue Feb 03, 2015 7:51 pm ] |
| Post subject: | Airflow Snorkel |
Does anyone have this installed or have a review? http://jeepinbyal.com/affiliate-product ... rkels.html Ran my CRD down a 1.5ft deep stream for a few hundred yards last weekend and, needless to say, I was pretty worried I would hit a drop at any moment. A snorkel would have put me at ease... plus they look BA! I've read a couple how-to-install guides on here, but no actual product reviews. Thanks! |
|
| Author: | tommudd [ Tue Feb 03, 2015 10:52 pm ] |
| Post subject: | Re: Airflow Snorkel |
Snorkel is only 50% of what you need, but if you do a search you'll find some who have installed |
|
| Author: | Balance156 [ Wed Feb 04, 2015 4:00 pm ] |
| Post subject: | Re: Airflow Snorkel |
1) Use di-electric grease on all electrical connections under the hood 2) Install high quality spark plug wires 3) Raise all your vent lines as high as you can - front / rear axle / tranny 4) Wrap my gas cap with electrical tape Would there be an issue with the fan? Anything else I am missing? Not looking at a snorkel simply for aesthetics. |
|
| Author: | ARB02KJ [ Sat Feb 07, 2015 6:50 pm ] |
| Post subject: | Re: Airflow Snorkel |
I've had my Air Flow on my KJ since they were first introduced into the US through Dirk at DPG off road, I believe around 2005/ 2006. I actually think I got it off a group buy from on here. Fit is great, the only areas where it was kinda troublesome were the templates. I just measured a million times and cut once.  Sent from my iPhone using Tapatalk |
|
| Author: | Lancer [ Sun Feb 08, 2015 4:11 am ] |
| Post subject: | Re: Airflow Snorkel |
Yep, the chap who fitted mine found that the templates were more of a rough guideline than a set of accurate markers! Use the templates as a guide only and measure, measure measure before you cut. |
|
| Author: | Arkie [ Sun Feb 08, 2015 11:20 am ] |
| Post subject: | Re: Airflow Snorkel |
Owning a muffler shop, and being moderately handy with oxy/acy weld, wire weld, metal fab, I've thought I'd like to attempt building my own. Any closeup pics of various components, finished installs? Bob |
|
| Author: | WHITE the civilian [ Sat Feb 21, 2015 4:13 am ] |
| Post subject: | Re: Airflow Snorkel |
Picked mine up off someone new for $300 and paid $400 to have it installed by a 4x4 shop.    
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|