| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Front DTT not pulling http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=81368 |
Page 1 of 1 |
| Author: | ktmrider [ Mon Feb 16, 2015 9:08 am ] |
| Post subject: | Front DTT not pulling |
May be hard to diagnose because I changed so much. I bought a used DTT and a front diff with a 4.10. Installed the DTT and then the whole thing in my Lib and the front end will not pull, Makes a howling noise and will turn with no load but will not pull with full weigh. Any idea what I did wrong? Did the rear also and it works great. The DTT looked like it had never been installed. |
|
| Author: | ktmrider [ Mon Feb 16, 2015 7:21 pm ] |
| Post subject: | Re: Front DTT not pulling |
Ok something is not right about the left side axle. Should the big part of the housing be flush with the differential? When its lifted it looks like its way to far out and the inner joint is in a pretty bad bind. But when weight is on the suspension the axle is straight but it does not look like its far enough inside the differential. Like possibly the axle is to short. They are new also and I checked the part number but I don't remember putting them beside the old ones to check. I did get alxes for a 3.7 and the front end is out of a 4 cylinder. I'm wondering now if the axle is wrong. |
|
| Author: | JeepinJarhead03 [ Fri Feb 27, 2015 7:57 pm ] |
| Post subject: | Re: Front DTT not pulling |
where did you get the new cvs if they aren't remans there's a good chance they are the wrong length |
|
| Author: | ktmrider [ Mon Mar 09, 2015 11:08 am ] |
| Post subject: | Re: Front DTT not pulling |
Ended up being the axle was not pushed up inside the diff far enough. Possibly damaged the clip going in but I'm up and running now. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|