Oh man.
I have always wanted to do this! Dreamed about it. But never dropped the hammer.
I'll be watching this. Keep the updates rolling please
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Engine Cylinder Specs and related shhhhhtuff... http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=81757 |
Page 1 of 1 |
| Author: | Rezfink [ Sat Apr 04, 2015 10:45 pm ] |
| Post subject: | Engine Cylinder Specs and related shhhhhtuff... |
Im doing my first engine rebuild. Bought a used 2004 3.7 engine. I do have a bore/cylinder gauge to check all points of the cylinders. What are the engine cylinder specs for a 3.7? At what diameter size do I go with an oversized piston ring? At what point do I go with an over sized piston? Im just asking right now...as far as I can tell the cylinders look good except for 1 and 2 they have a small ridge which I will remove with a reamer. Thanks |
|
| Author: | WhitbyKJ [ Sun Apr 05, 2015 7:17 am ] |
| Post subject: | Re: Engine Cylinder Specs and related shhhhhtuff... |
Oh man. I have always wanted to do this! Dreamed about it. But never dropped the hammer. I'll be watching this. Keep the updates rolling please
|
|
| Author: | tombo_ontario [ Sun Apr 05, 2015 11:01 am ] |
| Post subject: | Re: Engine Cylinder Specs and related shhhhhtuff... |
The bore and stroke etc. are all in the factory service manual if you have one. If not I'm sure you can find a PDF version online.. |
|
| Author: | Gyro [ Sun Apr 05, 2015 3:29 pm ] |
| Post subject: | Re: Engine Cylinder Specs and related shhhhhtuff... |
tombo_ontario wrote: The bore and stroke etc. are all in the factory service manual if you have one. If not I'm sure you can find a PDF version online.. You can here http://www.colorado4wheel.com/manuals/Jeep/KJ/ Gyro |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|