Need to relocate your rear brake line? No problem.
I used a piece of scrap steel that can be had from any metal supermarket for about 30 cents. (provided they have an off cut program)
Its a piece of 1 inch wide, 2 3/4 inches long, 1/8 thick hot rolled steel.
Step 1: Unbolt the brake line (10mm)
Step 2: Move the brake line over one notch in the plastic retaining clip. Be CAREFUL!! Don't break it.
Step 3: Drill your 30 cent piece of steel with a 1/4 inch or 27mm or 5/16 (I didn't check, it was so simple) in the fashion shown below.
Step 4: Use random hardware or fasteners you have laying around to bolt the plate onto the KJ. Tada!
