LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

CV shaft question
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=83486		 Page 1 of 1
Author:  HER_CRD [ Sat Nov 14, 2015 9:25 pm ]
Post subject:  CV shaft question
I'm working on doing ball joints and getting things put back together. I'm noticing that when I put the spindle assembly in and get the upper control arm, lower ball joint and tie rod end put in I can no longer turn the axle freely. If if remove the the spindle the axle and bearing turn fine. Did I mess something up?
Author:  tommudd [ Sat Nov 14, 2015 9:32 pm ]
Post subject:  Re: CV shaft question
Are you sure its all the way back in? ( the intermediate shaft/ CV )
Author:  HER_CRD [ Sat Nov 14, 2015 9:35 pm ]
Post subject:  Re: CV shaft question
Which one is that? The intermediate shaft is the one that is splined to the bearing, correct?
Author:  flash7210 [ Sat Nov 14, 2015 9:45 pm ]
Post subject:  Re: CV shaft question
Did you remove both front CV axles?
If so, they are different lengths, and maybe you got them mixed up.
Author:  HER_CRD [ Sat Nov 14, 2015 9:46 pm ]
Post subject:  Re: CV shaft question
No, shafts were not removed.
Author:  HER_CRD [ Sat Nov 14, 2015 9:49 pm ]
Post subject:  Re: CV shaft question
I can turn the bearing foot a bit but then something seems to bind.
Author:  flash7210 [ Sat Nov 14, 2015 10:08 pm ]
Post subject:  Re: CV shaft question
Are both front wheels off the ground?
Is the transfer case in 2wd or neutral?

The front wheel bearing/hub, when splined to the CV axle, and splined to the front differential, can be more difficult to turn by hand. But it should be just as difficult as before you took it apart.
Author:  HER_CRD [ Sat Nov 14, 2015 10:49 pm ]
Post subject:  Re: CV shaft question
Figured it out. Problem was actually the grease fitting on the lower ball joint rubbing the cv shaft. Took it out and put in a plug.Image
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/