| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Front Recovery Points http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=83605 |
Page 1 of 1 |
| Author: | Kanvas [ Wed Dec 02, 2015 7:33 am ] |
| Post subject: | Front Recovery Points |
Hi All Been looking at doing some front recovery points for awhile now and have been quite lucky not to need any; but everyone's luck runs out sooner or later. I picked up a set of generic recovery points that fit the Toyota Landcruiser, Nissan Navara etc after getting the idea from the hitch recovery points, and made a few modifications to fit the Liberty       Should hopefully be going on this weekend 
|
|
| Author: | tommudd [ Wed Dec 02, 2015 1:13 pm ] |
| Post subject: | Re: Front Recovery Points |
So how many bolts holding it on? I would fabricate a plate to go inside the frame rail so that you could bolt up through to it Nuts welded to the plate you slide back in Why did you cut them off so short? Just curious |
|
| Author: | Kanvas [ Wed Dec 02, 2015 7:36 pm ] |
| Post subject: | Re: Front Recovery Points |
tommudd wrote: So how many bolts holding it on? I would fabricate a plate to go inside the frame rail so that you could bolt up through to it Nuts welded to the plate you slide back in Why did you cut them off so short? Just curious Few more details - 2x M12x40mm 10.9 bolts Recovery points are 10mm 8620 steel plate 6mm 316 stainless backing plate will be inside the rails The reason for them being cut down slightly was so I can use the existing tow hook holes and still fit them between the radiator frame and front bar without protruding past the bumper (in Australia it is illegal to have any protrusion in front of the bumper unless its an accessory to an item incorporated into the bumper itself eg. winch accessories). EDIT: A couple more images of the recover points finished in Black zinc gal before they go on tomorrow.  
|
|
| Author: | Kanvas [ Tue Dec 08, 2015 5:12 am ] |
| Post subject: | Re: Front Recovery Points |
Well got them installed over the weekend and it couldn't have gone better  Still have a little bumper trimming to do but they're a pretty good fit!      
|
|
| Author: | JeepMorrison [ Tue Dec 08, 2015 12:17 pm ] |
| Post subject: | Re: Front Recovery Points |
Looks like a legit install Sent from my SM-N900P using Tapatalk |
|
| Author: | tommudd [ Tue Dec 08, 2015 7:39 pm ] |
| Post subject: | Re: Front Recovery Points |
Turned out really good, maybe an option for some over here if we can find the parts |
|
| Author: | AdrianBeaky [ Wed Dec 09, 2015 10:07 pm ] |
| Post subject: | Re: Front Recovery Points |
Those look incredible. Amazing job. IMO, they look better than the stock hooks. Sent from my XT1058 using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|