| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Difference right and left JBA front upper control arms? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=83629 |
Page 1 of 1 |
| Author: | jrsavoie [ Thu Dec 10, 2015 7:15 pm ] |
| Post subject: | Difference right and left JBA front upper control arms? |
IS there any difference between right and left on the JBA front upper control arms |
|
| Author: | Mountainman [ Thu Dec 10, 2015 7:35 pm ] |
| Post subject: | Re: Difference right and left JBA front upper control arms? |
jrsavoie wrote: IS there any difference between right and left on the JBA front upper control arms Nope, they are symmetrical according to the site |
|
| Author: | JeepMorrison [ Thu Dec 10, 2015 10:23 pm ] |
| Post subject: | Re: Difference right and left JBA front upper control arms? |
KJ same on each side. KK are different Sent from my SM-N900P using Tapatalk |
|
| Author: | jrsavoie [ Sat Dec 12, 2015 11:29 am ] |
| Post subject: | Re: Difference right and left JBA front upper control arms? |
Is there a good thread on changing the front upper control arms on a 2006 Jeep Liberty CRD? I got the right side to the point of letting it down and tightening things up I can't see the UCA bolt closest to the firewall on the right / drivers side yet. |
|
| Author: | Mountainman [ Sat Dec 12, 2015 1:08 pm ] |
| Post subject: | Re: Difference right and left JBA front upper control arms? |
jrsavoie wrote: Is there a good thread on changing the front upper control arms on a 2006 Jeep Liberty CRD? I got the right side to the point of letting it down and tightening things up I can't see the UCA bolt closest to the firewall on the right / drivers side yet. Not sure about a thread, but all I remember is that I cut some of those bolts shorter and reversed at least one of them so it wouldn't be so difficult the second time. |
|
| Author: | jrsavoie [ Sat Dec 12, 2015 1:46 pm ] |
| Post subject: | Re: Difference right and left JBA front upper control arms? |
Thanks for the reversing tip. I thought about that, but didn't know if it was permissible |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|