| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Got TPMS working on my 2004 w/steel wheels - Cragar Soft 8s http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=83638 |
Page 1 of 1 |
| Author: | johngr904 [ Fri Dec 11, 2015 8:39 pm ] |
| Post subject: | Got TPMS working on my 2004 w/steel wheels - Cragar Soft 8s |
For years my tpms hasn't worked because I couldn't get the EVIC to recognize my tpms valves using the training magnet. I finally found a solution that didn't involve trips to the dealership as my only option. I purchased on Amazon an ATEQ VT5 one button trigger tool. It uses radio frequency like the dealer to program the tpms valves. It took me 4 or 5 tries getting all 5 wheels trained, but now it works like a charm. I did have to play around with the tool, holding it close to and moving it around the stem, then away about a foot or so. And I'm not sure if this is required, but I finally got them trained properly after a 15 mile/20 minute drive with new valves installed. I think the tool was $65 or $70. There seem to be lots of tpms tools like this in the marketplace, this was just the cheapest I could find, and it worked. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|