LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Rear caliper bolt thread pitch?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=85489		 Page 1 of 1
Author:  minisub [ Mon Oct 24, 2016 9:35 pm ]
Post subject:  Rear caliper bolt thread pitch?
On my 2006 I have lost the thread on one of the rear caliper mounts. I want to put a helicoil in it and be able to retain the stock mounting caliper pins.

I have a decent set of dies and assorted hardware around and cannot match the size and thread pitch. After searching to the end of the Internet, i am unable to find confirmation on the size of these buggers.

I think they are M9 x 1.25 and 50 mm long. Not even Fastenal has this size to check.

Anyone know for sure?
Author:  WWDiesel [ Tue Oct 25, 2016 11:40 am ]
Post subject:  Re: Rear caliper bolt thread pitch?
The OEM number for the bolt is: 06507603AA
Could not find the size listed anywhere for this part no.
If you still have one of the bolts, you should be able to measure the bolt with a metric caliper and a metric thread pitch gauge?

Look at this bolt guide, page 2, it covers metric bolt sizes.>>http://us.mt.com/dam/mt_ext_files/Editorial/Generic/5/bolt_thread_types_dimensions_0x0002464400026aa20006025d_files/bolt.pdf
It does not list an M9 size as 9mm is a very rarely used bolt size, most go from M8 to M10! :roll:

Helicoil does not list any M9 coils: (see page 13)
http://www.stanleyengineeredfastening.com/sites/www.emhartamericas.com/files/downloads/Heli-Coil_Catalog_HC2000_Rev12.pdf
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/