Howdy,

Does anyone else have an issue with the central (overhead) info display 'resetting' itself randomly?
Over here in the UK we're a bit confused about our mix of metric/imperial, so we use miles, MPG and then degrees C (generally) for the temperature, so I switch between the settings now and then (when I feel a nip in the air).

On regular occasions however, my "X miles to go" fuel display swaps itself to "X km to go", so I need to go in an reset it back to "U.S.".

Just wondering if there's a dodgy wire/connector/relay somewhere perhaps?

Not massively urgent, but if anyone's come across this before, I'd be grateful of some light shed.

Ta muchly

_________________
2004 Liberty KJ (Cherokee) 2.5 CRD Limited

Kent, Southeast UK

My display resets if power is cut. It uses unswitched power lead for memory. While doing my retrofit it reset whenever I disconnected power. Now that it is in it only resets if the battery went dead or I pulled the battery cable when servicing.

_________________
Now have GDE full torque eco tune and eco transmission tune. Used an 02 liberty trans computer for my new trans tune.

Finally bit the bullet and replaced the battery (as my old one was on its last legs).
Seems to have cured the problem with the display resetting.

I wonder if the low power reset it constantly (as mentioned by dennyb, above)?

Anyway, happy days!

_________________
2004 Liberty KJ (Cherokee) 2.5 CRD Limited

Kent, Southeast UK