I bought the 9.5172R bushing from amazon and they fit if you open up the holes a little bit. Our studs are a bigger OD and slightly farther apart that the slots on the bushing bracket.
So far it has been noise free.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Energy Suspension poly sway bar bushings http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=87745 |
Page 1 of 1 |
| Author: | mass-hole [ Thu Jan 25, 2018 8:11 pm ] |
| Post subject: | Energy Suspension poly sway bar bushings |
I bought the 9.5172R bushing from amazon and they fit if you open up the holes a little bit. Our studs are a bigger OD and slightly farther apart that the slots on the bushing bracket. So far it has been noise free. |
|
| Author: | Myke [ Fri Jan 26, 2018 9:48 pm ] |
| Post subject: | Re: Energy Suspension poly sway bar bushings |
Ok now find ones for the lca/clevis. |
|
| Author: | mass-hole [ Mon Jan 29, 2018 5:19 pm ] |
| Post subject: | Re: Energy Suspension poly sway bar bushings |
Myke wrote: Ok now find ones for the lca/clevis. I already started a thread just a few down from this one. We got the LCA measurements but I seriously doubt anything will be plug-n-play. I think its honestly easier to just buy new LCA's |
|
| Author: | mass-hole [ Tue Jan 30, 2018 2:08 pm ] |
| Post subject: | Re: Energy Suspension poly sway bar bushings |
So far so good on these. No noises or anything. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|