Hello all. My name is Matt and I'm from reading pa. I am new to the liberty scene, but have experience in the 4wd/lifting area. I work at an automotive repair shop where I am the manager. My dad also runs his towing company out of the same area. I acquired this liberty after it was rolled over by the previous owner. The passenger's side banged up and engine hydro locked with motor oil; perfect for an off-road build. After swapping out some doors and windows, and pulling the plugs to expel the oil from the cylinders, I decided to lift it. I've put plenty of lift kits on (and also made my own) so since a good size kit is so expensive for the liberty I used some old parts from other vehicles. Rear coil springs are stock from the front of a tj, rear shocks are f150, I used cheap coil spring spacers I had laying around and then I purchased 2 strut mounts (factory liberty) and cut them up to space out the body from the strut. I will be doing much more modding to it, so keep an eye out for updates. Glad to be on the page!

A few other personal vehicles