LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

new seattle member
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=43&t=86559		 Page 1 of 1
Author:  206libertycrd [ Fri May 12, 2017 5:02 pm ]
Post subject:  new seattle member
Hey guys i bought myself a nice clean 2006 crd 4x4. got a good deal on it. has about 138k miles. Sent in my ECU to gde already. keith was alot of help in pointing me to idparts. i plan on doing timing belt, tensioner, lifters and rockers, alternator pulley, fan clutch, and little stuff in between. basically wanting to bulletproof the big service stuff as much as possible. its going to be my daily driver for a long time so i want to do everything i can to make sure it lasts.
Author:  GordnadoCRD [ Fri May 12, 2017 11:56 pm ]
Post subject:  Re: new seattle member
They are a significant item, but since you're already doing the timing belt, You might want to consider pulling the "valve cover" / Intake manifold, and Replace the headbolts with ARP studs, as headgaskets are a known weak point over time, with the "Torque to Yield" stock headbolts. And since you're there check the lifters and replace any that show wear, (or just do a whole set) since they are another known weak part, and usually are the first point to fail if the engine has not been maintained properly by the P.O.
If bulletproofing is what you're after, you should probably add these to your budgeting list
Kind of a pay once, cry, and drive with more confidence.
Welcome to the CRaDventure!
Author:  pacaba [ Sat May 13, 2017 6:22 am ]
Post subject:  Re: new seattle member
Hey there and welcome to the website! This is a very friendly and nice place! See you around the forums! Also, post pictures of your jeep, please :P thanks!
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/