I am finally going to get around to installing the light bar this weekend. Went through the instructions and got all my tools ready. But I can't figure out what the heck step 12 is telling me to do and why I should drill 1 hole that is 13mm??? Anyone who has done this have any idea?

TIA

http://site.justforjeeps.com/guide/82206126AB.pdf

_________________
2005 Limited CRD

It's one of several holes you need to drill to make it all happen. Check out my write up, there are some tips there that will save you soem time and trouble.

_________________
2006 CRD http://www.UtahPowderCoatings.com/ http://www.gorecon.com/ I'm kind of a big deal.
RL rear bumper, ARB front bumper, Mile Marker winch, Power Tank, Skids by Mopar & Skid Row, RL Super Skink Sliders, 235/85R16 MTR, Air Flow Snorkel, DTT, 4.10 gears, Frankenlift II, Katskin leather, JL Audio stereo, Rosen video.

Thanks - I've got your write up printed out with my instructions. It will definatly save me some trouble.

Just the logic of the different size hole for this one is throwing me off. I'm sure it will be obvious when I get into it, I just want to make sure before I start drilling.

_________________
2005 Limited CRD

Step 12 is just to basically inlarge a hole in the light bar base,not the roof panel just the plastic base.

I think Jeep has the guys from IKEA do their directions too.

_________________
Nanette

03 Freedom with some neat stuff done to it that I learned about here.