| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Where did you ground your amp? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=45&t=3504 |
Page 1 of 1 |
| Author: | eddiev9 [ Thu Nov 17, 2005 12:43 pm ] |
| Post subject: | Where did you ground your amp? |
Anyone have an amp installed under the rear seat, driver's side? Where did you ground your amp (if you didn't drill a hole)? When I installed my first amp under the driver seat, there was an existing 'grounding point' over toward the front, left corner 'leg' of the seat; under the carpet a couple inches to the right of where the seat bolt mounts. I had hopes there may have been something similar in the rear, but I couldn't find one...so I just mounted it with the 'leg' of the rear seat where it gets bolted down. It's probably not a good idea, which is why I'm asking for ideas. Thanks! |
|
| Author: | Bonehead [ Thu Nov 17, 2005 4:04 pm ] |
| Post subject: | |
I used one of the back seat mounting studs to ground mine. |
|
| Author: | eddiev9 [ Thu Nov 17, 2005 7:27 pm ] |
| Post subject: | |
Bonehead wrote: I used one of the back seat mounting studs to ground mine.
Hey, Bonehead. I think we spoke on a different forum before. How's it going? Well, then I guess I'm okay since we grounded our amps in a similar way. Did you sand off all the paint around the mounting studs? (I didn't  )
|
|
| Author: | Neatus [ Mon Nov 21, 2005 12:09 am ] |
| Post subject: | |
Quote: I used one of the back seat mounting studs to ground mine.
Same here |
|
| Author: | huntin12ga [ Fri Nov 25, 2005 3:08 pm ] |
| Post subject: | |
If you like to run wire you can mount yours where I mounted mine. I took up the plastic guard on the floor where the gate opens and mounted it to the metal there. I have never had problems with it and it gets the wire out of the way. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|