| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| installing sound damping, window leakage normal? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=45&t=37187 |
Page 1 of 1 |
| Author: | SBosco [ Sun Nov 09, 2008 12:27 am ] |
| Post subject: | installing sound damping, window leakage normal? |
I have been installing sound damping material in my doors in my spare time over the last few weekends. I have been using spray sound damping on the inside surface of the outer door shell and on the inside of the plastic door panel, as well as Cascade Audio VB-2 sound damping mat (non-asphalt based dynamat alternative) over the interior door shell. The passenger doors are all done and interior panels are back on, but I am still working on the driver doors. Last sunday I sprayed the drivers side doors and panels and had to wait for them to dry before applying the mat over the door. It was a rainy saturday today, and I was going to apply the mat over the doors today. However, before I started I noticed there was water dripping into the door from both sides of the window track. It wasn't a lot...no accumulation really but enough for me to be concerned about. I haven't checked the passenger side yet because I really don't want to rip off the mat I worked so hard to install. Now, I have had all 4 window regulators replaced under factory warranty. Are windows typically 100% watertight? Is this normal? I have a feeling that if I take it to the dealership now, they will tell me to go screw myself. Is there anything I can do myself to seal it up? Opinions, and/or experiences anybody? Thanks. |
|
| Author: | tjkj2002 [ Sun Nov 09, 2008 2:46 am ] |
| Post subject: | |
Normal,you should also notice the drains in the bottom of the doors where the inner/outer skins are joined to drain that water. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|