| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Trailer Hitch Wiring Harness http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=45&t=37652 |
Page 1 of 1 |
| Author: | PaU-MWolverine [ Mon Nov 24, 2008 7:01 pm ] |
| Post subject: | Trailer Hitch Wiring Harness |
HI, I'm looking to add a trailer hitch (which I have) and the wiring. I bought the harness on Friday, but I'm having a hard time figuring out where this wiring harness gets spliced in. I was told that it was located behind one of the taillights... I need someone's expertise. Thanks in advance! |
|
| Author: | jsc7002 [ Mon Nov 24, 2008 7:42 pm ] |
| Post subject: | |
just pull off the taillight and there is a connector that you disconnect and plug in the harness, its really simple I bet if you just pull the taillight off you'll see how it goes |
|
| Author: | PaU-MWolverine [ Mon Nov 24, 2008 9:47 pm ] |
| Post subject: | |
Is it either taillight, or one or the other specifically? I was told maybe the driver's side... Thanks! |
|
| Author: | 501 [ Mon Nov 24, 2008 9:57 pm ] |
| Post subject: | |
The one I bought from Advanced Auto connected behind both taillights. Make sure you put a cloth between the rear fender and the hanging tail light or you will scratch the crap out of the fender (I did it to my driverside). |
|
| Author: | PaU-MWolverine [ Tue Nov 25, 2008 3:55 am ] |
| Post subject: | |
501 wrote: The one I bought from Advanced Auto connected behind both taillights. Make sure you put a cloth between the rear fender and the hanging tail light or you will scratch the crap out of the fender (I did it to my driverside).
That's where I bought the harness I have. Hopefully I can try it w/in the next 2 weekends. Do you have any suggestions where to run the wiring then? Along the underside of the rear bumper, I guess... Thanks. |
|
| Author: | 06 KJ Sport [ Tue Nov 25, 2008 12:01 pm ] |
| Post subject: | |
How much was the kit from Advanced Auto?? |
|
| Author: | PaU-MWolverine [ Tue Nov 25, 2008 6:10 pm ] |
| Post subject: | |
The harness was only $15 or $16 at Advance. Pretty reasonable, I think. Although I am certainly no electrician, mechanic, etc. That's why I want to be sure of what I'm doing before I go ripping stuff apart. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|