Ok, so I have my eyes on a Westin bull bar and then putting some lights on it, (never have too much light) (these are just throughts right now too)

but when it comes to running the wiring into the cabin for the on off control I want to totally integrate this into exisitng controls that are in my dash.

So my thoughts are the switches that are at the bottom of the radio panel that are for the hazards, ESP, hill decent, and what ever else is there, right now I have 2 open slots, one on each end and my thoughts are to order a switch from parts instead of using what ever comes with the lights.

I just don't know what the right switch would be, I'm sure one of these would work, anyone help me out here?

http://www.berrysprinter.com/e-fiche/mo ... 9/08kk.pdf

Page 99 of 520 on the PDF is the switches on instrument panel

So no one has a lending hand with this.

I'm thinking the same switch as the one used for the 115V outlet? any suggestions?

_________________
Bill and the divided Danette

2009 Liberty Sport 4x4
Sky Slider
Factory Tow Package
Super Expensive Gutter Screen Grill Inserts
24" of PPF on the front
Factory skids
AEM intake, Scanguage II
Skink Super Sliders, 3/8" Boiler Shims
Stops here for now....baby here!!!

i have no idea, TBJ and Boiler are switch junkies though

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632