| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Dash gauge help http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=45&t=42965 |
Page 1 of 1 |
| Author: | JeepinJarhead03 [ Thu May 07, 2009 4:09 pm ] |
| Post subject: | |
this is what my manual says for acutuator test and of course prior to the descrip, it says to disconnect the neg batt terminal for 2 mins to discharge the airbag capacitor prior to testing to prevent accidental discharge, according to the description of the test, its the proper way to recal the needles (1) Begin the test with the ignition switch in the Off position. (2) Depress the odometer/trip odometer switch button. (3) While still holding the odometer/trip odometer switch button depressed, turn the ignition switch to the On position, but do not start the engine. (4) Release the odometer/trip odometer switch button. (5) The instrument cluster will automatically begin the actuator test sequence, as follows: (a) The cluster will turn on, then off again each of the PCI data bus message controlled indicators to confirm the functionality of the indicator and the cluster control circuitry: (b) The cluster will sweep the needles for each of the gauges to several calibration points in sequence to confirm the functionality of the gauge and the cluster control circuitry: (c) The cluster will sequentially step the odometer/ trip odometer VFD display from all ones (111111) through all nines (999999) to confirm the functionality of all VFD segments and their control circuitry, then display the software version number. (d) The cluster will generate five (5) chime tones to confirm the functionality of the audible tone generator and the control circuitry. (6) The actuator test is now completed. The instrument cluster will automatically exit the self-diagnostic mode and return to normal operation at the completion of the test, if the ignition switch is turned to the Off position during the test, or if an engine rpm message indicating that the engine is running is received from the PCM over the PCI data bus during the test. (7) Go back to Step 1 to repeat the test, if required. |
|
| Author: | JeepinJarhead03 [ Fri May 08, 2009 3:05 am ] |
| Post subject: | |
were you putting in LED bulbs in there or what? we had found led replacements for just about all the bulbs i think first dash bulb that goes and they're all getting led'ed |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|