| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| amplifier wiring set up http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=45&t=8280 |
Page 1 of 1 |
| Author: | odhinn [ Sun May 07, 2006 11:27 pm ] |
| Post subject: | amplifier wiring set up |
i wish somebody could help me run the wires for basslinkII, i need the fastest and easiest way to run it from the cargo area. pictured instruction is highly appreciated. i guess any other amplifier set up would help. thanks. |
|
| Author: | wilfredcruz [ Mon May 08, 2006 9:02 am ] |
| Post subject: | |
Well, sorry I don’t have photos.. But this is the way I had done it before, I no longer have the basslink. Power wire goes from battery thru a rubber thing in the firewall. In here there is a thread on how to go thru firewall. Then run it under the left sided body panel close to carpet, you need to lift it up, it will come out easily. The rear panel won’t come out but you could slide the cable under it and hook it to the sub. The ground I hooked to one of the rear seat bolts. The signal from radio behind console, under carpet, close to side panel and then to basslink and also the remote (blue wire) I used RCAs for signal. Do you have stock radio or aftermarket? I had aftermarket. If you have stock you will need a converter to convert speaker level to RCAs, also you neen to find your remote, I think is a light green wire. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|