LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

No-Drill CB Mount, Front of hood
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=45&t=8902		 Page 1 of 1
Author:  Se7enLC [ Wed May 24, 2006 9:27 pm ]
Post subject:  No-Drill CB Mount, Front of hood
I just got the mount for CB in the mail today. I used the Firestick kit for the Dodge Ram hood (MK184R from Walcot CB)

Image

The hole is already in the side of the panel and it lined up perfectly with the mount. I used a 5/16 bolt (3/4" long) with a couple washers, a lock washer, and a nut. Holds nicely.

Here's what it looks like on the jeep:
Image

I haven't finished wiring it up, yet. I think I will try to snake the cable through the firewall-hole if I can figure out how to get the plug out.

Should be good for keeping an eye on the CB when going under stuff. Also, it bends down so you can grab it in the drivers seat, if need be.

More close-up photos on my cardomain site
Author:  Edwin [ Fri May 26, 2006 5:06 pm ]
Post subject: 
That's differant, I kinda like it. Great job partner.
Author:  Se7enLC [ Fri May 26, 2006 5:11 pm ]
Post subject: 
Edwin wrote:
That's differant, I kinda like it. Great job partner.


Thanks!

It makes the jeep sorta look like an RC car with the giant antenna on the hood :-) Sorta like a dune flag, even
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/