I feel silly asking this question, but I removed my #3 injector and bought a new copper crush washer and o ring, but for the life of me, I can't remember if the o ring goes into the slot somewhat close to the end of the injector or further up close to the top resting on a shoulder?

I can't seem to find a schematic anywhere on the web or perhaps it's my search engine in my iPad. Anyway, can anyone help? Thanks!

Ken

_________________
2006 CRD
2.5 Frankenlift,ARB front bumper with internal winch.snorkel soon to have rock lizard bumper, sliders and roof rails, 2nd gen filter head
GDE eco tune-need trans upgrade and new TC
Beaverton Oregon

In the slot on the injector

Sent from my SCH-I535 using Tapatalk

_________________
Trevor

'05 Limited CRD Inferno Red Pearl Coat
Home made provent installed @ 35443, SEGR installed @ 35466, Fumoto valve @ 37500, trans and transfer case skid, In tank pump installed @ 43500, Suncoast TC & Transgo Shift Kit @ 44730, EGT, Boost, Trans temp gauges, Samco hoses, Rebuilt Trans w/ HD454RFE kit @ 56K, Inmotion Stage 2 @ 56K

It goes near the top to keep dust out.

_________________
20 year owner of Libby CRD!
2006 LTD Bright Silver loaded with all the needed mods, CCV intact.
Equipped with HDS thermostat, plenty of heat, faster warm-ups, increased fuel mileage.

That's what I thought. When I went to install the injector I started second guessing myself so I thought I better ask the question.
I'm surprised that I could not find any pictures on the web. Thanks for the help!

Ken

_________________
2006 CRD
2.5 Frankenlift,ARB front bumper with internal winch.snorkel soon to have rock lizard bumper, sliders and roof rails, 2nd gen filter head
GDE eco tune-need trans upgrade and new TC
Beaverton Oregon