Hello every one,
I am in need of a parking brake adapter plate for my 05 CRD.
The part No. 52128415ACfor the left (driver) side is not longer available from Mopar.
My research found several sources that list a plate that comes in three sections rather than one single plate, and they do not list the manufacturer source. cost varies from $190 to $400 for the pair (both sides).
Have any one have had experience with these three pieces plates?
Any comments would be sincerely appreciated,

Best,
Sergio

_________________
Sergio05CRD

The stock plate is a single piece of metal, I assume the 3 piece would mean you would not have to remove the axle. Possible it attaches over the old plate? Do you have a link for the part?

_________________
20 year owner of Libby CRD!
2006 LTD Bright Silver loaded with all the needed mods, CCV intact.
Equipped with HDS thermostat, plenty of heat, faster warm-ups, increased fuel mileage.

Yes , that makes sense. But to remove the old one I will need to remove the axle anyhow.
The link is from Partsgeck ? They list three versions and the one from Reproparts ? is 18363-09352162. they also list one from Dorman at twise the cost.

_________________
Sergio05CRD

With the right tools, you can cut the old one, and not remove the axle.

Here's some chinesium ones, like most are, cut out the middle man.

https://www.ebay.com/itm/366395785571?f ... R4Dezd37Zw

_________________
20 year owner of Libby CRD!
2006 LTD Bright Silver loaded with all the needed mods, CCV intact.
Equipped with HDS thermostat, plenty of heat, faster warm-ups, increased fuel mileage.

Thanks for the info.
I will proceed with caution. Cutting out the old one wont be easy with the tools that I have available.

_________________
Sergio05CRD