| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Standard or metric? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=11780 |
Page 1 of 1 |
| Author: | AZ CRD [ Sat Aug 26, 2006 10:29 am ] |
| Post subject: | Standard or metric? |
Dumb question, I know. I assembled an emergency tool kit for my CRD containing standard open-end wrenches. Then, I changed out my license plate frame to "Powered by BIODIESEL" and found the bolts to be 10mm. What is the rest of the vehicle? |
|
| Author: | oldnavy [ Sat Aug 26, 2006 10:38 am ] |
| Post subject: | Re: Standard or metric? |
AZ CRD wrote: Dumb question, I know. I assembled an emergency tool kit for my CRD containing standard open-end wrenches. Then, I changed out my license plate frame to "Powered by BIODIESEL" and found the bolts to be 10mm. What is the rest of the vehicle? Everything I have put a wrench to is metric, 10mm Allen wrench for transfer case even. I think the differential cover is SAE, but don't remember for sure. The hose clamps are 8 mm nuts, the CCV is 8 mm or 10 mm, don't remember for sure and the battery is metric but but don't remember for sure, but I think it was 10 mm also and anything on the engine itself is metric.
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|