It is currently Fri Nov 06, 2026 1:24 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 6 posts ] 
Author Message
 Post subject: Favor please? And a question...
PostPosted: Wed Sep 06, 2006 4:12 pm 
Offline
LOST Member

Joined: Sun Jul 10, 2005 6:30 pm
Posts: 443
Location: Phoenix, AZ
When you get the chance, before starting your vehicle, could you pop the hood and turn the motor on. Let it run for 30 sec. or so and shut it off. Do you hear any buzzing coming from the driver side down by the block?
I had the buzzing sound and cel light on that everyone else had. While researching the parts, I became confused with all the part numbers associated with the EGR system. What was replaced was 5166555AB. Is this the correct part for the EGR valve or the EGR Flow Control Valve? The sound is still there but much more muted and almost unnoticeable whith the hood closed. I was wondering if this is a normal sound or if the work was not done correctly.Thanks for your help!

Dave

_________________
2005 Black CRD Sport
All J CRD Frankenlift with 500 fronts, Boulderbars, and Superskid
Kilby Gas Skid
Yukon Rear Axles
265/75 16 TrXus M/T's and Bridgestone Revo's
Fumoto Valve
Aero Turbine 2525
Rock Lizard Komodo Bumper
Sundance Custom's Front Bumper


Top
 Profile  
 
 Post subject:
PostPosted: Wed Sep 06, 2006 4:26 pm 
Offline
LOST Member
User avatar

Joined: Thu Apr 13, 2006 10:53 pm
Posts: 111
Location: Indianapolis, Indiana
My EGR flow control was replaced about 5k miles ago. When it went bad, the noise was very, very loud. It sounded like a mixer in a metal bowl turned on high.

The new one does make a very low hum and always has since it was installed...but it can really only be heard when the hood is up like you mentioned. I would say that it is normal.

_________________
2005 liberty Sport CRD


Top
 Profile  
 
 Post subject:
PostPosted: Wed Sep 06, 2006 10:12 pm 
Offline
LOST Newbie

Joined: Mon Mar 27, 2006 12:09 am
Posts: 66
Location: Bonham, Tx
The most noticable difference when I had my EGR flow control valve replaced was how "softly" the engine died when the key was turned off. When my flow control valve was bad, it died with a pretty hard kick!

_________________
05 Silver KJ Limited CRD born July 11, 2005
'88 Suzuki Samurai 4x4
'99 1/2 Powerstroke 4 door Dually 4x4
Kubota B7200 Diesel 4x4
Polaris 700 and 500 H.O. 4x4


Top
 Profile  
 
 Post subject:
PostPosted: Wed Sep 06, 2006 10:31 pm 
Offline
LOST Member
User avatar

Joined: Mon Jul 10, 2006 9:52 pm
Posts: 131
Location: Keller, TX
Mine's pretty quiet too ... a very slight hum with the hood up for about 15-30 seconds or so ....

_________________
2006 CRD Sport 4X4, bought 6 July 2006, born 5/20/2006 1900 hrs.
Mods N Things:
235/70r16 Wrangler SilentArmor, ProVent, Gasser airbox, CAT filter, Kennedy lift pump, fuel cooler, Evic from wrecked 05 KJ, factory skidplates, towhooks, OME 2" CRD lift, Magnaflow 12256 muffler, Alpine stereo & XM "stealth antenna" install


Top
 Profile  
 
 Post subject:
PostPosted: Thu Sep 07, 2006 10:43 am 
Offline
LOST Member
User avatar

Joined: Thu Apr 13, 2006 10:53 pm
Posts: 111
Location: Indianapolis, Indiana
Mykol wrote:
The most noticable difference when I had my EGR flow control valve replaced was how "softly" the engine died when the key was turned off. When my flow control valve was bad, it died with a pretty hard kick!


Good point. Mine does the same. When it was going bad, and right before the bit loud noise started, the engine started to kind of "rumble" to a stop when I shut it down.

Now, it just stops dead when I turn the key off.

_________________
2005 liberty Sport CRD


Top
 Profile  
 
 Post subject: ditto
PostPosted: Thu Sep 07, 2006 3:14 pm 
Offline
LOST Junkie

Joined: Sat Jul 09, 2005 6:06 pm
Posts: 610
Location: somewhere in MO
IndyCRD wrote:
Mykol wrote:
The most noticable difference when I had my EGR flow control valve replaced was how "softly" the engine died when the key was turned off. When my flow control valve was bad, it died with a pretty hard kick!


Good point. Mine does the same. When it was going bad, and right before the bit loud noise started, the engine started to kind of "rumble" to a stop when I shut it down.

Now, it just stops dead when I turn the key off.


Ditto the above

_________________
Sold 05 CRD Patriot Blue, hole in the roof, Trailer tow, factory skids, LSD, Saris load bars, Michelin LTX M/S
Current Bright white 2010 Dakota Quad Cab 4x4 V8


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 6 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 9 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com