| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Noise in Rear of CRD http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=12911 |
Page 1 of 1 |
| Author: | richardkf [ Thu Sep 28, 2006 7:35 am ] |
| Post subject: | Noise in Rear of CRD |
When I leave the CRD sitting overnight and back up in the morning, there is a light clunk kind of noise coming from the right rear of the CRD. It is always parked overnight on level ground and after I drive forward for even just a few feet, when I back up again, no more noise. Had the dealer check the fluids in the transfer case and they were fine. Transmission fluid is fine too. Any ideas? |
|
| Author: | dog_party [ Thu Sep 28, 2006 10:34 am ] |
| Post subject: | |
Might not be the same thing you're talking about, but my morning clunk used to drive me crazy. Then I did thorough testing on it and found it to be the swing-gate locking mechanism engaging. It seems to engage upon initial movement, unlike the door that auto-lock at a higher speed. Like I said, I don't know if that's the type of "clunk" that you're talking about, but it's what mine does. |
|
| Author: | Zonie [ Thu Sep 28, 2006 10:49 am ] |
| Post subject: | |
I have the same problem only then I get a thunka-thunka-thunka in the back until the car is rolling for about 1/2 mile. There is a service bulliten that addresses the problem and has quite an extensive brake fix including calipers and rotors. Someone on here suggested that I print the Chryser bulliten and take it in with me. I'll try to enclose it here. if it doesn't work, the number is 05-004-06, Date: July 19, 2006, Group: Brakes. I have it on a Word document, but it will not cut and paste. If you want to PM me an e-maill address, I'll send you the document. Otherwise you can search on the Forum. It's on here somewhere. [/img] |
|
| Author: | richardkf [ Thu Sep 28, 2006 2:22 pm ] |
| Post subject: | |
Zonie wrote: I have the same problem only then I get a thunka-thunka-thunka in the back until the car is rolling for about 1/2 mile. There is a service bulliten that addresses the problem and has quite an extensive brake fix including calipers and rotors. Someone on here suggested that I print the Chryser bulliten and take it in with me. I'll try to enclose it here. if it doesn't work, the number is 05-004-06,
Date: July 19, 2006, Group: Brakes. I have it on a Word document, but it will not cut and paste. If you want to PM me an e-maill address, I'll send you the document. Otherwise you can search on the Forum. It's on here somewhere. [/img] Thanks Zonie, PM sent. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|