I bent the plastic rear bumper in the left corner just below the tag. Does any one know where the best place to buy a replacement (and the cost) and how difficult is it to replace. Can I do the replacement or should I take it to a body shop? Thanks

These are the good replacements
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=22282&highlight=rock+lizard+rear+bumper

although it's 110 lbs of steel and you have to paint it yourself.....

To get the stock rear off - wasn't too difficult - I think 3 sheet metal screws in the center top, 6 pop rivets 3 on each side - 2 screws on each side (hard to get to - under the fender lip) - I also had to drill out 4 rivets - but they were holding on the crush cans in the center - if you're just doing the bumper it's not neccessary.

To buy a new bumper - you're probably looking at a dealer - you might try Ebay (although if you get it off - you might be able to pop it out from the inside)

_________________
2005 CRD
stuff
Skeptic quod gratis asseritur, gratis negatur

If I were in the US I would sell you mine as I am looking to get the e-spec bumper for mine.

_________________
No longer a CRD or Jeep owner. Selling everything I have, needs to go as I need the room for a project.

rear bumper cover, shop price, $170.

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic