LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Torque Mgmt Request lead
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=33871		 Page 1 of 1
Author:  greiswig [ Fri Jul 04, 2008 1:13 pm ]
Post subject:  Torque Mgmt Request lead
In his thread on the SEGR installation, gmctd pointed this pin out:

"Interestingly enuff, here is C1-11 Torque Management Request pin - hmmmm......what's gmctd up to, now, eh?"

Is this guy the secret to getting back the torque that the F37 recall destroys? Anyone tinkered with this? It's probably PWM, so it wouldn't be trivial to fool, but...
Author:  Joe Romas [ Fri Jul 04, 2008 1:35 pm ]
Post subject: 
MrMopar gave the pinouts also and wished anyone trying it "Good Luck" :wink:
Author:  Sir Sam [ Fri Jul 04, 2008 1:43 pm ]
Post subject: 
someone here removed the torque management request pin. may not be the best idea ever, or at least not the best without a suncoast.
Author:  greiswig [ Fri Jul 04, 2008 2:15 pm ]
Post subject: 
Sir Sam wrote:
someone here removed the torque management request pin. may not be the best idea ever, or at least not the best without a suncoast.


Implication of this statement is that this lead only makes torque reduction requests. Is that true? I'd love to hear from whoever tried this...I assume it threw a code of some kind, but did it get anything back performance-wise?
Author:  gmctd [ Fri Jul 04, 2008 7:20 pm ]
Post subject: 
I intended to series-in a switch, but didn't get to see the little mule enuff to do so - it's on the list, along with the switched pressure-offset - doesn't seem to do much, no CEL's, but I never got to drive it B4 the severance, so dunno if it makes any diff at all - the Hemi guys routinely cut it loose
Author:  greiswig [ Fri Jul 04, 2008 7:41 pm ]
Post subject: 
gmctd wrote:
I intended to series-in a switch, but didn't get to see the little mule enuff to do so - it's on the list, along with the switched pressure-offset - doesn't seem to do much, no CEL's, but I never got to drive it B4 the severance, so dunno if it makes any diff at all - the Hemi guys routinely cut it loose


Thanks, gmctd. I can't tell from this sentence which item doesn't seem to do much and doesn't throw a code: is it the torque request lead, or the pressure offset lead?
Author:  gmctd [ Fri Jul 04, 2008 7:56 pm ]
Post subject: 
Pressure offset works, if installed - TMRS hasn't seemed to do much
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/