Hey, I have a gasser, but wanted to use stock CRD springs to level out my kj after the winch mount was installed. I have been trying to get a part number for some CRD springs but can't seem to do it. Can anyone help me? I am looking for springs with a rate of 500 lb/in or so. Would any CRD front spring set do? Should I just get a VIN off of autotrader.com and call the dealer with that? Help and/or part numbers would be much appreciated.
thanks all
Stephen

_________________
04 5sp. with mods

http://www.cardomain.com/ride/798121

http://www.lostjeeps.com/forum/phpBB3/vie ... hp?t=24600

I put in OME springs, suggest you call OME Technical Support to get the correct springs.
Stock origional manufacturers springs were weak junk, bottomed out.

Thank Sir Sam.

_________________
'06 Jeep Liberty Sport CRD with: GDE Hot Flash and Tranny Flash, ehm, Cummins fuel pump, 3" Magnaflow muff, Moog K3199's, Skids, 225-75-16 10 ply, OME springs, Euro T/C, Shift kit, Trans cooler w/thermal bypass, Bigboy bkt, Samco CAC, Brake controller, Trans temp gauge, Al's Upper Arms

I put the Franklin Lift on which uses the OME springs. If you want my old stock CRD springs, you can have them. Just pay for the shipping. Let me know.

OME only have lifted springs, and I am not lifted That has to wait for a year or so. Turbo Tim, I would be glad to take your springs off your hands, I just want to make sure they are stiff enough? My zip for shipping is 94544. Let me know how much they would be to ship.
thanks
Stephen

_________________
04 5sp. with mods

http://www.cardomain.com/ride/798121

The 500lbs rate coils are the OME 790's,stock CRD coils are 410lbs rated springs just to let your know.

PM sent. Let me know.