It is currently Tue Nov 03, 2026 12:25 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Has anyone tried the Inmotion stage 1.5 tune?
PostPosted: Mon Jul 21, 2008 7:46 am 
Offline
LOST Junkie

Joined: Fri Feb 17, 2006 9:39 pm
Posts: 676
Location: Saylorsburg, PA
Hi all,

Has anyone else tried the Inmotion stage 1.5 tune? It's intended to be a middle ground between the power tune and the economy tune. We had it flashed onto our ECM several months ago. So far, my wife and I find that the fuel economy is unchanged or slightly worse, and it takes more pedal travel to get the little beast moving. My wife has been complaining that she does not like the way it drives anymore. To me, it feels like my old turbo Dodge did when the fuel pressure regulator failed and the rail was getting 40psi instead of 55psi.

On paper, the stage 1.5 tune is only a handful of ft-lbs down from the power tune. Power tune is 335ft-lbs, eco-tune is 329ft-lbs, and this stage 1.5 is supposed to be in the middle (with improved fuel economy). But, it feels much slower than the power tune did. Perhaps there's something wrong with our vehicle, like a vacuum leak somewhere? It would be good to get some other data points to compare to our experiences.

Thanks!

- Chris

_________________
Used to own:
2006 CRD Sport
Suncoast TC, Transgo shift kit, Inmotion, ORM, EHM, Magnaflow SS exhaust, Fumoto valve, EVIC added, Hensley TruControl brake controller, Pirelli Scorpion ATR LR-D in spring/summer/fall, FIA winter front and Blizzaks in winter


Top
 Profile  
 
 Post subject: Cleaned The MAP Sensor Lately?
PostPosted: Mon Jul 21, 2008 1:05 pm 
Offline
Lifetime Member
Lifetime Member

Joined: Sun Mar 09, 2008 7:58 pm
Posts: 696
Location: Backwoods, ME
I am just about to check my MAP sensor again.
Just did the air filter and oil change.
Any other suggestions?

_________________
'06 Jeep Liberty Sport CRD with: GDE Hot Flash and Tranny Flash, ehm, Cummins fuel pump, 3" Magnaflow muff, Moog K3199's, Skids, 225-75-16 10 ply, OME springs, Euro T/C, Shift kit, Trans cooler w/thermal bypass, Bigboy bkt, Samco CAC, Brake controller, Trans temp gauge, Al's Upper Arms


Top
 Profile  
 
 Post subject:
PostPosted: Tue Jul 22, 2008 2:23 am 
Offline
LOST Newbie

Joined: Fri Jul 18, 2008 7:19 am
Posts: 30
Location: Indiana and North Carolina
Just wondering if I read the Inmotion site right we send them our original ECU and a second one that they will clone and burn for us is this correct thanks.

_________________
Mine 2010 6.7L Dodge Ram 3500, Crew Cab, Long bed, Dually, 4x4 no mod's yet but a few are planned
The Wifes 2005 CRD Liberty with Fumoto Valve, Scangauge II, 2.5" straight pipe, EHM, and EGR unplugged awaiting poss Water Meth and a 2" lift kit


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com