LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

I need CRD springs part number, can anyone help?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=34356		 Page 1 of 1
Author:  swyszomirski [ Wed Jul 23, 2008 1:53 am ]
Post subject:  I need CRD springs part number, can anyone help?
Hey, I have a gasser, but wanted to use stock CRD springs to level out my kj after the winch mount was installed. I have been trying to get a part number for some CRD springs but can't seem to do it. Can anyone help me? I am looking for springs with a rate of 500 lb/in or so. Would any CRD front spring set do? Should I just get a VIN off of autotrader.com and call the dealer with that? Help and/or part numbers would be much appreciated.
thanks all
Stephen
Author:  fastRob [ Wed Jul 23, 2008 7:47 am ]
Post subject:  Found in: CRD Tech Only
http://www.lostjeeps.com/forum/phpBB3/vie ... hp?t=24600

I put in OME springs, suggest you call OME Technical Support to get the correct springs.
Stock origional manufacturers springs were weak junk, bottomed out.

Thank Sir Sam.
Author:  Turbo Tim [ Wed Jul 23, 2008 10:04 am ]
Post subject: 
I put the Franklin Lift on which uses the OME springs. If you want my old stock CRD springs, you can have them. Just pay for the shipping. Let me know.
Author:  swyszomirski [ Wed Jul 23, 2008 10:40 am ]
Post subject: 
OME only have lifted springs, and I am not lifted :( That has to wait for a year or so. Turbo Tim, I would be glad to take your springs off your hands, I just want to make sure they are stiff enough? My zip for shipping is 94544. Let me know how much they would be to ship.
thanks
Stephen
Author:  tjkj2002 [ Wed Jul 23, 2008 10:48 am ]
Post subject:  Re: I need CRD springs part number, can anyone help?
swyszomirski wrote:
Hey, I have a gasser, but wanted to use stock CRD springs to level out my kj after the winch mount was installed. I have been trying to get a part number for some CRD springs but can't seem to do it. Can anyone help me? I am looking for springs with a rate of 500 lb/in or so. Would any CRD front spring set do? Should I just get a VIN off of autotrader.com and call the dealer with that? Help and/or part numbers would be much appreciated.
thanks all
Stephen
The 500lbs rate coils are the OME 790's,stock CRD coils are 410lbs rated springs just to let your know.
Author:  Turbo Tim [ Wed Jul 23, 2008 11:55 pm ]
Post subject: 
PM sent. Let me know.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/