| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Confirm SEGR is working properly? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=35725 |
Page 1 of 1 |
| Author: | DOC4444 [ Sun Sep 07, 2008 9:12 pm ] |
| Post subject: | Confirm SEGR is working properly? |
It's been about 500 miles since install. No CELs. ACTRON pocket scanner shows no codes. No signs of anything wrong, but how do you determine that it is doing all that it is supposed to? Thanks, DOC |
|
| Author: | longview [ Sun Sep 07, 2008 11:10 pm ] |
| Post subject: | |
Clean your MAP sensor. Then next oil change, clean it again. Notice the difference? If so, it is working. |
|
| Author: | UFO [ Sun Sep 07, 2008 11:34 pm ] |
| Post subject: | Re: Confirm SEGR is working properly? |
DOC4444 wrote: It's been about 500 miles since install. No CELs. ACTRON pocket scanner shows no codes. No signs of anything wrong, but how do you determine that it is doing all that it is supposed to? If it wasn't working, you would have a CEL. The act of physically cutting the wire to the EGR when you installed it ensures the EGR doesn't operate. All the SEGR does is keep the light off.
Thanks, DOC |
|
| Author: | DOC4444 [ Mon Sep 08, 2008 8:53 pm ] |
| Post subject: | Confirm SEGR is working |
Thanks! DOC |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|