| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Lovely, lovely fuel pump http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=39353 |
Page 1 of 1 |
| Author: | Bill.Barg [ Mon Jan 19, 2009 12:26 am ] |
| Post subject: | Lovely, lovely fuel pump |
Just changed the fuel filter. The "in tank fuel pump" is great for purging the air from the filter. Hard to imagine the pain in the arse this mundane task would be without it. Also... removing the whole filter assembly (two nuts at the firewall) makes the filter change easy. The lift pump is well worth the effort. Thanks Diesel LOST forum ! |
|
| Author: | MTB_TDI [ Mon Jan 19, 2009 12:34 am ] |
| Post subject: | |
Same here. The lift pump make that job much easier!!! Did a few weeks ago. |
|
| Author: | dgeist [ Mon Jan 19, 2009 9:37 am ] |
| Post subject: | even better with a littleder valve... |
I did mine a few months back and opened the brass bleeder valve I installed (with a plastic tube into a bottle). Turned the key to "on" and waited for the bottle to start filling with diesel, then pour the bottle back into the tank and DONE. I almost can't remember how much of a PITA it was before the pump. Kinda like after having a child: What was it like not to be a parent? Can't remember 
Dan |
|
| Author: | chrispitude [ Mon Jan 19, 2009 1:41 pm ] |
| Post subject: | Re: Lovely, lovely fuel pump |
Bill.Barg wrote: Also... removing the whole filter assembly (two nuts at the firewall) makes the filter change easy.
Last time I spun the filter off from underneath with a band filter which used a long 3/8" ratchet extension. When you removed the two nuts, does the assembly lift up enough to remove the filter without disconnecting the fuel lines? Or must that be done too? - Chris |
|
| Author: | Joe Romas [ Mon Jan 19, 2009 1:56 pm ] |
| Post subject: | Re: Lovely, lovely fuel pump |
chrispitude wrote: Bill.Barg wrote: Also... removing the whole filter assembly (two nuts at the firewall) makes the filter change easy. When you removed the two nuts, does the assembly lift up enough to remove the filter without disconnecting the fuel lines? - Chris YES  And it's easy to get the wire off the water in fuel sensor too 
|
|
| Author: | midwest [ Mon Jan 19, 2009 2:49 pm ] |
| Post subject: | Re: Lovely, lovely fuel pump |
Bill.Barg wrote: Just changed the fuel filter.
The "in tank fuel pump" is great for purging the air from the filter. Hard to imagine the pain in the arse this mundane task would be without it. Also... removing the whole filter assembly (two nuts at the firewall) makes the filter change easy. The lift pump is well worth the effort. Thanks Diesel LOST forum ! I just changed my filter also (50k on the CRD) and was able to do it from above after disconnecting the two electrical connectors plus the water in fuel sensor. I think the trick is to follow the instructions and install it hand tight. As for the "pain in the arse" about priming the filter it wasn't that difficult. Just 10-15 pumps, then start the engine. It ran a few seconds then died. 10-15 more pumps and it started and ran fine. NEVER opened the bleeder valve. I guess i'm lucky I don't have many of the problems others have. |
|
| Author: | tonycrd [ Mon Jan 19, 2009 5:34 pm ] |
| Post subject: | |
I just found this in my FSM...so I already have one? That's new to me.. This is supposed to sit inside the fueltank. And my '02 has an access cover in the trunk (according to the FSM). 
|
|
| Author: | gmctd [ Mon Jan 19, 2009 6:27 pm ] |
| Post subject: | |
FSM covers gasser (patooie!) versions, in addition to Diesel versions |
|
| Author: | tonycrd [ Mon Jan 19, 2009 6:54 pm ] |
| Post subject: | |
Yeah, but I found this in my 2.5/2.8 diesel supplement under 'fuel system'... 
|
|
| Author: | gmctd [ Mon Jan 19, 2009 7:08 pm ] |
| Post subject: | |
Then you should hear a whirrrr from the back seat the instant the IGN switch is keyed ON |
|
| Author: | ATXKJ [ Mon Jan 19, 2009 11:10 pm ] |
| Post subject: | |
he's got the 2.5 with Racor style fuel head - MrMopar64 said those had a lift pump (of course I've never seen one - but it sounds reasonable) |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|