LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

What parts do I need for a timing belt job?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=43224		 Page 1 of 1
Author:  CRD Joe [ Sat May 16, 2009 5:08 pm ]
Post subject:  What parts do I need for a timing belt job?
Coming from the VW TDI world where people sell timing belt KITS that you can buy I was wondering if I was going to put together all the parts necessary to do a timing belt kit what would I need to complete that kit?

I'd like to put togeher two kits. One for the next change and one for a future change!!!
Author:  ATXKJ [ Sat May 16, 2009 7:26 pm ]
Post subject: 
I don't think there's a kit

I'd recommend gasket, tensioner, idler pulleys and maybe even a water pump (and the belt of course)

and you need specialty tools to hold the cams in position.
Author:  CRD Joe [ Sat May 16, 2009 7:28 pm ]
Post subject: 
Thanks AT. Ill start looking for the parts.
Author:  RJM [ Sat May 16, 2009 9:23 pm ]
Post subject: 
ATXKJ wrote:
I don't think there's a kit

I'd recommend gasket, tensioner, idler pulleys and maybe even a water pump (and the belt of course)

and you need specialty tools to hold the cams in position.


Same as above, for the amount of work to pull it apart, I would for sure put in a new WP you would hate to get it all together an have it start leaking 500miles down the road, miller tools for this job is a must! 1 notch out on the belt and your in trouble. There is a member who has the tools in the " tech section" I as well have a full set but live in Canada so it would be better to get them from him. or her??
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/